View Full Version : Reamer
05-10-2011, 11:35 PM
Is this what is used to ream holes drilled in peened bolsters?
05-11-2011, 12:13 AM
Adam that will work but you will have to be very careful not to twist it in too far. What I do is to drill an 1/8th inch hole completely through the blade/bolsters then come back and step drill about half way through the bolster only with a bit that is only one size over in this case a #30 then install pin and peen as normal
05-11-2011, 12:25 AM
I use a carbide rasp on my rotary.
Scroll down towards the bottom. It works well for me if I take it slow.
05-11-2011, 12:27 AM
Thanks Bill. I'll try your route then.
Powered by vBulletin® Version 4.2.2 Copyright © 2015 vBulletin Solutions, Inc. All rights reserved.