PDA

View Full Version : Vise Advice



mr drinky
05-12-2011, 12:41 AM
This weekend I am going to start refining my new sharpening station, but I also want to attach a vise to the bench.

There are a ton of vise options out there, so are there some qualities that make some better for knife duties than others (size, mounts, material etc.) I am sure any of them would work, but if something is better, then I might as well invest in that instead.

k.

Darkhoek
05-12-2011, 08:27 AM
I have found the Stanley multi angle vises to be very useful. I have two of them in my workshop and they are versatile and stable enough for my work.

http://www.google.no/imgres?imgurl=http://toolmonger.com/wp-content/uploads/2007/11/StanleyVise_2.jpg&imgrefurl=http://toolmonger.com/2007/11/15/stanleys-new-maxsteel-multi-angle-vise/&usg=__fQs5nb7M0GElNoUM6NNUz5xEzhQ=&h=299&w=450&sz=62&hl=no&start=0&zoom=1&tbnid=c1CS5laR-8hN7M:&tbnh=141&tbnw=185&ei=ydLLTb_WB8Or-Qb5-sS0Aw&prev=/search%3Fq%3Dstanley%2Bvise%26um%3D1%26hl%3Dno%26s a%3DN%26rls%3Dcom.microsoft:no:IE-SearchBox%26biw%3D1357%26bih%3D714%26tbm%3Disch&um=1&itbs=1&iact=hc&vpx=124&vpy=92&dur=3781&hovh=183&hovw=276&tx=95&ty=102&page=1&ndsp=30&ved=1t:429,r:0,s:0

DarKHoeK

PierreRodrigue
05-12-2011, 08:41 AM
You can find a nice knifemakers vice at Jantz Supply, multiple angles, and looks quite solid.

Pierre

Marko Tsourkan
05-12-2011, 12:06 PM
I think a medium-large machinist vise (vintage Wilton) would be very useful in any workshop. For angled setup, I like a pipe vise that could be mounted in your machinist vise or bolted to a bench.

Are there any welders on this forum who could make pipe-vise that looks like this. This could be a good item to trade for.
http://www.usaknifemaker.com/knife-vise-swivel-base-p-1715.html

http://www.northcoastknives.com/Vise11Lrg.jpg

Alternatively, one can buy one for about $150-200 shipped. Pricey, but is could be very useful for handle work and detailed work.





M

SpikeC
05-12-2011, 01:40 PM
I just use a woodworking vise for most things, and clamp a handscrew in it for angled type work. I have a machinist vise as well. There are too many options, I think!

mr drinky
05-12-2011, 08:41 PM
Thanks everyone for the suggestions. Now I have a lot to choose from and now I have to narrow it down.

k.