View Full Version : Having trouble making flat grinds on my grinder.
05-05-2013, 07:27 PM
I have noticed that when I put wood for handles against my flat platten that my grinder will make the wood convex by either grinding the top, bottom, or both more than the center. I am pretty sure I am applying even pressure, and I have it so the belt is resting against the platten when the grinder is off. Am I doing something wrong, or do I just need to get better at grinding? Thanks for the help.
05-05-2013, 08:50 PM
The abrasive grabs the leading edge of the material and pulls it down.
05-05-2013, 08:56 PM
So how can I combat this? Just practice?
05-05-2013, 09:12 PM
I've never been able to use a belt grinder to the flatten the inside of wood scales as nice as I want them. I had to get a disc grinder for this task. This is a whole lot better (98% good to go) but still I find that I have to finish by hand to get them dead ass flat.
05-05-2013, 09:14 PM
Thanks. That is exactly what I needed.
05-05-2013, 09:32 PM
So how can I combat this? Just practice?..
....and sharp belts.
As soon as I notice my belt starting to dull I replace it.
A light touch with sharp belts, or a disc sander.
05-06-2013, 04:35 AM
I find the join bump in the abrasive belt causes excessive abrasion on the leading edge of whatever you're sanding. I haven't been able to over come it yet.
05-07-2013, 09:48 PM
A good hand plane will produce a nearly perfect surface. Of course, that's more tools, more sharpening, and another whole ball of wax!
A piece of adhesive sandpaper stuck down well to a flat surface will do a better job than a belt of any type, but it's slower.
Powered by vBulletin® Version 4.1.8 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.