View Full Version : Finishing re handle
06-21-2013, 05:59 AM
So, I did a re handle for a friend on a sabatier... he bought some stabilized walnut burl scales on ebay. They are cool, but there are a few voids -small, shallow openings - in the wood. How do you guys finish your handles when the scales have that going on. also, what is the basic finishing you guys do on stabilized wood regularly?
06-21-2013, 08:35 AM
06-22-2013, 12:02 AM
Small voids can usually be filled with a couple drops of CA glue (super glue).
Apply glue, let dry, repeat if necessary. Then sand.
For larger voids I use fast cure epoxy mixed with sanding dust from the wood.
After you have finished sanding apply a coat of Danish or Tung oil. Let dry and repeat a few times.
Then rub down with 0000 (extrafine) steel wool.
Then apply a paste wax for wood and hand buff with a soft cloth.
This works well on coarse grain woods like Walnut.
The multiple coats of Tung or Danish oil fill the pores for a smoother surface.
The most common mistake I see knife makers make is not filling the pores and then power buff.
That tends to put buffing compound in the open pores resulting in a dull, muddy finish.
Powered by vBulletin® Version 4.2.2 Copyright © 2015 vBulletin Solutions, Inc. All rights reserved.