View Full Version : Sharpening Question
08-27-2011, 03:13 PM
Just wondering... When you sharpen, do you follow the "only put on pressure when pushing/pulling the edge away" rule?
How many of you still follow this, every single time you sharpen?
08-27-2011, 03:14 PM
only on the back side of single bevel knives
08-27-2011, 03:25 PM
I try no matter what to keep consistent pressure. To me if you focus on applying varied amounts of pressure it will lead to inconsistency in angles. By principle it makes sense and I think it is natural to apply more pressure in this manner but it is only something I think about with de-burring.
I don't really change the amount of pressure too much. At least not concsiously... I don't use a lot of pressure to begin with, though. Jon recently told me to sharpen like I meant it when I was trying out a stone, haha. I told him that's how I always sharpen and especially light on the finishing stones.
08-27-2011, 04:56 PM
Not every time, and not consistently within a session. It's not a critical thing, methinks. It did help me to speed up when I was newer, but it required a bit more focus to maintain the angle. Obviously, it wears the stone unevenly, so keep that in mind.
08-28-2011, 10:57 AM
I keep consistent on push and pull strokes...the only time I change pressure is lightening it as I finish on each stone, and as I progress through stones, but the push/pull stays the same throughout.
Powered by vBulletin® Version 4.1.8 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.