View Full Version : Community pass arounds question!
11-27-2011, 01:06 AM
I have noticed that all the pass arounds that happen are always for a 240mm or 270mm gyuto or for a 270mm or 300mm sujihiki.
Why don't knife makers do pass arounds for cleavers, pettys, nakiris etc... I'm sure people would love to give a try to some other types of knives.
Just a thought and something Ive noticed!:plus1:
lots of people buy and use multiple gyutos and a fair number use multiple sujis. they are big blades and are more difficult to design and execute well. cleavers are a PITA to make. good performing pettys are relatively easy to make and obtain. not very many people seem to be willing to pay $200-500 for a petty even though it isn't proportionally less work to make. edge retention is also not a major issue because of lack of board contact. very few members use nakiris and of those, few have used more than a couple.
11-27-2011, 10:10 AM
Yeah, there are only a few of us who are big nakiri fans - and those of us who like 'em aren't always vocal about it either :)
11-27-2011, 11:13 AM
Most people use gyutos for 85% of their kitchen work, and a gyuto is tricky because it's a bit of a balancing act. Since you are trying to make an "all-rounder", it shows where the maker's priorities are, and how the design lends itself to being used.
Powered by vBulletin® Version 4.2.2 Copyright © 2014 vBulletin Solutions, Inc. All rights reserved.