View Full Version : W's Pattern 180mm Petty finished.

12-17-2011, 03:01 PM
Got this one all finished today. It been nearly done for a while, but I needed to re-finish so I could etch my logo then re-etch and fit the handle. This one is off to its new owner in France on monday.
Blade length is 180mm
Blade height - 36mm
Taper is -2.4mm- 1.8mm -0.8mm
Handle length - 128mm, Burlsource redwood with black wood ferrule.
Slightly convex faces,
The damascus is in 75ni8 and en42j
Sharp now too:D

12-17-2011, 03:06 PM
Great job.
Very pedantic fit and finish

Andrew H
12-17-2011, 03:29 PM
Great job.
Very pedantic fit and finish

Haha I don't think I'd use pedantic. Great job, Will, it turned out very well.

12-17-2011, 03:35 PM
Wow that's handsome. Redwood looks really nice.

12-17-2011, 03:41 PM
Thanks very much, actually in this case I don't mind being called pedantic, anal might being going too far:lol2:
A customer has bought this for a relative, so i'm a little nervous as I don't know much about the new owner. I'm including some instructions, a welsh honing slate, which will do him for touch ups and some chromium oxide/balsa. Hope it doesn't end up in the dishwasher after 24 hours:nono: I'll have to send him an e-mail too I think with some video links and a link to the forum.:thumbsup:

12-17-2011, 08:47 PM
Very nice work! Hopefully it goes to someone who will appreciate it.

12-17-2011, 09:14 PM
I had a hard time saying how much I like this knife because I couldn't stop looking at it. That's such a pretty petty. I think I need to get on your list.

El Pescador
12-17-2011, 09:31 PM
Good looking petty!

Mike Davis
12-17-2011, 11:17 PM
Very nice Will, that pattern is stunning, And the FnF is top notch!

12-18-2011, 05:34 AM
Thanks very much you guys.:biggrin:I enjoyed making it.:biggrin: