View Full Version : Any Interest for Oval or Octagonal Handles for Cleaver?

Marko Tsourkan
02-23-2012, 01:36 PM
I have a few pieces of cow horn that I got from a vendor in Europe. The length 1" is a bit short for my knife handles and quality is lower than I would like for premium handles, however it is still a pretty decent quality horn that is hard to get and will be priced accordingly (moderately).

So, I have been thinking what to do with it. The length and diameter makes it suitable for cleaver handles.

Is there an interest for these? If I make them, they would have to be same size, self-installed or sent to Dave for installation.

I have about 15 pieces of 1x1.5"(diameter) cow horn.


02-23-2012, 02:10 PM
Looking for two unique handles for my two cleavers, pics?

My personal e-mail is hax9215@aol.com

Hax the Cook CLEAVERS RULE!!! :D