View Full Version : Forgot to introduce myself first
03-29-2011, 02:08 PM
I Posted before I started an introduction thread here. My name is Larrin, I'm graduating this May with a bachelors degree in Materials Science and Engineering at the University of Nevada-Reno and I've been accepted to Colorado School of Mines in Metallurgical Engineering in a PhD program in their steel research center. My father is Damascus steel and knife maker Devin Thomas.
03-29-2011, 02:27 PM
Devin Thomas? Unfamiliar ;)
Nah welcome Larrin, youre knowledge is much valued here :)
03-29-2011, 02:31 PM
Hi Larrin, I'm glad to have you here. :)
03-29-2011, 03:05 PM
Hi, Larrin. Your reputation precedes you here. Virtually everyone here knows and respects you from KF.
03-29-2011, 05:11 PM
x2. Glad to see you on the board and already contributing great info on steel compositions!
03-29-2011, 05:28 PM
Hey Larrin-pull up a stool at the counter over here! As long as you're here, here is a steel question for you! McMaster-Carr has 2 different quenching oils, one is called fast quench and one is called slow quench. Which one is best for O1 steel?
03-29-2011, 05:31 PM
Glad to see you here. I can't wait for the epic steel debates!
03-29-2011, 07:12 PM
The slow quench is probably sufficient for O1 because of its deep hardening, but the fast quench probably wouldn't give you any problems with knives, and could possibly get you a higher hardness.
03-29-2011, 09:08 PM
Thanks, Larrin! I managed to spill about 3 quarts of oil today, so I think I will reorder some fast quench!
Powered by vBulletin® Version 4.1.8 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.