Been a while since I did a WIP
Here is a bit of a WIP on a little knife I am working on, comments welcome!
Starting materials. Bog oak, mammoth tooth, maple dowell, fiber spacers, and a hunk of black buffalo horn
Handle materials assembled, at this point the tang slot is in place, and the dowel is inside the handle, to provide an extra mechanical bond.
Next, removing the surplus on the 36 grit belt.
Attachment 8929Attachment 8934
Squaring the handle.
Attachment 8930Attachment 8931
Setting the bevels.
Attachment 8932Attachment 8933
Next the sanding smooth, and sealing the mammoth and horn.