Quantcast
Search Results - Kitchen Knife Forums

Search:

Type: Posts; User: Dave Jacobson

Search: Search took 0.00 seconds.

  1. New belts and variable speed motors are always...

    New belts and variable speed motors are always nice but it's all about how much pressure you apply.
  2. Replies
    3
    Views
    399

    Tig weld with 309 s.s. or super missile rod.

    Tig weld with 309 s.s. or super missile rod.
  3. Replies
    16
    Views
    787

    It might be a better idea to just put new scales...

    It might be a better idea to just put new scales on it.
  4. Replies
    12
    Views
    2,405

    Nice job

    Nice job
  5. Replies
    21
    Views
    783

    Welcome Josef!

    Welcome Josef!
  6. Replies
    18
    Views
    1,127

    By changing direction you can see the fine...

    By changing direction you can see the fine scratches from the stone cross each other. If your strokes are always in the same direction when you turn the blade over to see progress you cannot tell...
  7. Replies
    13
    Views
    1,089

    Wow!! That's got some hours into it.

    Wow!! That's got some hours into it.
  8. Replies
    18
    Views
    1,127

    When your sharpening on a water stone, keep...

    When your sharpening on a water stone, keep changing the direction slightly every 15-20 strokes then look at the blade , you will be able to see where you need to put more pressure and where to put...
  9. Replies
    3
    Views
    1,407

    California hammer-in

    This is definitely worth the drive. Meet some great people and awesome knifemakers. http://www.americanbladesmith.com/ipboard/index.php?/topic/1207-california-hammer-in/
  10. Replies
    29
    Views
    4,239

    If you use ferric chloride mix it with water 50%...

    If you use ferric chloride mix it with water 50% and make sure the blade is super clean.You can use finger nail paint to seal up around the handle where you don't want it to get to. Soak it for about...
  11. Replies
    2
    Views
    467

    I would start with a leaf spring or coil spring....

    I would start with a leaf spring or coil spring. it's most likely 5160 which is a easy steel to heat treat.

    Here's a list of what types of steel you can find for free. ...
  12. Replies
    9
    Views
    1,859

    I've often wondered what would be the best way to...

    I've often wondered what would be the best way to go about grinding teeth like that into a hardened blade without making a mess of it.
  13. Replies
    6
    Views
    449

    I like to rip off a 3/8" thick section of a...

    I like to rip off a 3/8" thick section of a yellow j-flex belt and do it on the slack part of the grinder, then hand sand with sandpaper wrapped around a sharpie.
  14. Replies
    32
    Views
    1,799

    It could be that the martensite grain size in...

    It could be that the martensite grain size in that area is not as small due to heat treating methods or it could of been overheated in that area causing the grain structure to grow.
  15. Replies
    15
    Views
    403

    Hello from Santa Cruz California.

    I stumbled across this forum while researching info about chef knives. This is a wonderful forum to know about as it has given me information about knives from pro chefs who actually use them rather...
Results 1 to 15 of 16