Quantcast
Search Results - Kitchen Knife Forums

Search:

Type: Posts; User: grelcar

Search: Search took 0.00 seconds.

  1. Thread: Magnets

    by grelcar
    Replies
    12
    Views
    1,711

    Thanks for the responses. I have been researching...

    Thanks for the responses. I have been researching magnets. I want to go with round magnets so I can use a forstner bit in the drill press. I plan to drill the holes as deeply as I can without risking...
  2. Thread: Magnets

    by grelcar
    Replies
    12
    Views
    1,711

    Magnets

    I have a beautiful piece of figured maple that I want to use to make a magnet knife rack for my kitchen. This board is about 2 1/2 inches wide, just over 2 feet long and an inch thick after squaring...
  3. Replies
    19
    Views
    1,367

    I have purchased AUS-8 and 440C blades from a...

    I have purchased AUS-8 and 440C blades from a couple of the big knife supply sources. The AUS-8 blanks were very thing, sharpened well, but chipped easily. The 440C blades I have purchased were...
Results 1 to 3 of 3