Looks good to me too, great to see the first sketches/designs.
Profile is just fine. I'm sure you have an idea of thickness measurements along the blade. How then do we go at the tip?
How tall is it at the heel? Little extra height here would be nice
Once we figure that we are ADC ( awful damn close) I will crank out a rendering with dimensions.
Here are the specs on my rendition...
50mm high at the heel
250mm cutting edge
2.5mm spine at the bolster
1.5mm mid spine
.8mm 1 inch from the tip, give or take of course...
Sounds great. Not to thick ,not too thin. Good height and taper. You're not wasting any time Pierre.