Quantcast
How to make a Knife Sheath out of PVC - Page 2
+ Reply to Thread
Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: How to make a Knife Sheath out of PVC

  1. #11
    Senior Member
    Join Date
    Sep 2012
    Location
    Seattle, WA USA
    Posts
    242
    Quote Originally Posted by Burl Source View Post
    Warning!
    I saw the photo where he is going to cut the pipe on the table saw.
    Round objects can roll if the saw blade grabs the piece.
    Potentially pulling your fingers into the blade.
    Dead right! PVC cuts really easy even by hand with a hacksaw.

  2. #12
    mkriggen's Avatar
    Join Date
    Mar 2013
    Location
    Hawai'i
    Posts
    677
    Not quite what I would call a presentation saya, but pretty slick and probably a step up from the cheap (if you call $4-5 cheap) edge guards from the local "cutlery" shop. As far as scratching goes, it shouldn't be a problem as long as the knife is clean when you put it away (the PVC itself is pretty soft). I'd recommend using the cheap 200psi rated pipe as it's much easier to shape then the thicker sch40 or 80 pipe. When applying the heat be careful not to scorch the plastic, keep the hot air gun moving and stop when the plastic just starts to deform. If you don't have a hot air gun just do a "Home Depot rental" (buy-use-return), they wont mind (if they ask why, tell them you didn't like the color)

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts