WIP - Making a Saya

Kitchen Knife Forums

Help Support Kitchen Knife Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Marko Tsourkan

Founding Member
Joined
Feb 28, 2011
Messages
5,005
Reaction score
34
I didn't document every step, but you should get an idea about the process.

Excess TruOil removed - 24hrs drying
DSC_0570.jpg

Generously Coated in TruOil
DSC_0569.jpg

Hand Sanded to 320 grit
DSC_0568.jpg

Ground to 120grit - Blending Lines
DSC_0567.jpg

Rough Ground - Bevels and Chamfers and Giving Saya Shape
DSC_0566.jpg

Rough Ground - Bevels and Chamfers
DSC_0565.jpg

Glued Up and profiled
DSC_0564.jpg

Carved and Fitted
DSC_0563.jpg


Carved and Fitted
DSC_0562.jpg


Carved and Fitted
DSC_0561.jpg


Carved and Fitted
DSC_0560.jpg


Carved and Fitted
DSC_0559.jpg
 
Marko, what chisels are you using, do you have any pictures of them? I remember you saying that flex is crucial in saya nomi, so I'm curious what you're working with.

I think your pictures/documentation is backwards too. Looks awesome though.
 
I use Japan Woodworker saya chisels in 3/8 and 3/4". I outline a profile, then make a cut on a profile, then carve to that cut. 3/8 chisel is good at carve to the profile, while the 3/4 is good at removing bulk of material.

M
 
Nice work Marko.
Thank you for posting the photos.
 
Thanks Marko. I was always wondering: with a thicker knife, would you carve both pieces or still only one?

Stefan
 
Never both, as when you clamp, there will be a slight movement on the halves, causing them misallign. For a thicker knife, you start with a thicker board and leave more material on a side where cavity is carved. However, for knives like Shigefusa, I carve the cavity on both sides to accommodate rapidly thickening spine at the handle, but just up to 2.5" on the side opposite to where cavity is carved.
 
Back
Top