WIP - Making a Saya

Kitchen Knife Forums

Help Support Kitchen Knife Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Marko Tsourkan

Founding Member
Joined
Feb 28, 2011
Messages
5,005
Reaction score
34
I didn't document every step, but you should get an idea about the process.

Excess TruOil removed - 24hrs drying
DSC_0570.jpg

Generously Coated in TruOil
DSC_0569.jpg

Hand Sanded to 320 grit
DSC_0568.jpg

Ground to 120grit - Blending Lines
DSC_0567.jpg

Rough Ground - Bevels and Chamfers and Giving Saya Shape
DSC_0566.jpg

Rough Ground - Bevels and Chamfers
DSC_0565.jpg

Glued Up and profiled
DSC_0564.jpg

Carved and Fitted
DSC_0563.jpg


Carved and Fitted
DSC_0562.jpg


Carved and Fitted
DSC_0561.jpg


Carved and Fitted
DSC_0560.jpg


Carved and Fitted
DSC_0559.jpg
 
Marko, what chisels are you using, do you have any pictures of them? I remember you saying that flex is crucial in saya nomi, so I'm curious what you're working with.

I think your pictures/documentation is backwards too. Looks awesome though.
 
I use Japan Woodworker saya chisels in 3/8 and 3/4". I outline a profile, then make a cut on a profile, then carve to that cut. 3/8 chisel is good at carve to the profile, while the 3/4 is good at removing bulk of material.

M
 
Nice work Marko.
Thank you for posting the photos.
 
Thanks Marko. I was always wondering: with a thicker knife, would you carve both pieces or still only one?

Stefan
 
Never both, as when you clamp, there will be a slight movement on the halves, causing them misallign. For a thicker knife, you start with a thicker board and leave more material on a side where cavity is carved. However, for knives like Shigefusa, I carve the cavity on both sides to accommodate rapidly thickening spine at the handle, but just up to 2.5" on the side opposite to where cavity is carved.
 

Latest posts

Back
Top