kalaeb
Banned
- Joined
- Feb 28, 2011
- Messages
- 2,426
- Reaction score
- 2
I was bored and decided to re-handle an old cheese knife I have had for about 15 years. This was going to be a simple easy project.
I would like to drill my own pin holes in the tang because I am doing a series of 1/8 inch mosiac pins instead of the traditional rivets. The only problem I am running into is I can't drill the stupid holes. I have currently burned up three 1/8 bits and have not even punched the first of five holes. :angry1:
This stainless is crazy hard, I have never had this type of problem.
So the question is, what type of drill bit should I be using? I have burned through a Rigid, Bosch and Dewalt bit? Any advice would be greatly appreciated.
Matt
I would like to drill my own pin holes in the tang because I am doing a series of 1/8 inch mosiac pins instead of the traditional rivets. The only problem I am running into is I can't drill the stupid holes. I have currently burned up three 1/8 bits and have not even punched the first of five holes. :angry1:
This stainless is crazy hard, I have never had this type of problem.
So the question is, what type of drill bit should I be using? I have burned through a Rigid, Bosch and Dewalt bit? Any advice would be greatly appreciated.
Matt