Help Support Kitchen Knife Forums by donating using the link above or becoming a Supporting Member.
Results 1 to 3 of 3

Thread: Another Etched Tanaka

  1. #1
    Senior Member
    Join Date
    Jun 2013

    Another Etched Tanaka

    Followed Dave's guide using a 2:1 Vinegar/Acid dip. It's a new Tanaka 160mm Petty, won the Tanaka lottery with this one (unlike my gyuto ), straight as an arrow good cutter OOTB. Prepped by sanding the it. I had spent a fair amount of time rounding the spine and choil 220/400/600/1k sandpaper. Knocked the handle off using a plastic cutting board and hammer, luckily wasnt epoxied on. Petty was just short enough to fit in an nalgene type container I had laying around. Not knowing what to expect, checked in 5 min intervals, ended up removing after 10min. Scrubbed down with some #000 steel wool and water. All in all pretty easy once you gather all the materials.

    Color came out really nice, darker than what's in the pictures. The lighter parts are a very smooth gunmetal which I dig. Being a nit-pick only areas that didn't come out perfect was a tiny spot on the heel (not sure why it didn't darken) and the right side behind the kanji the etch came out lighter (laquer or coating?). I noticed acid ate away at my smoothed spine a bit, tempted to sand down again but that'll probably discolor that part of the blade. Cut some onions afterwards, not as reactive let the juice sit on the blade for a while, it started to discolor after about 4min. Anyone know if BKF will take off the acid etch?

    Tempted to resand and dip again to see if I can get the damascus contrast to pop more..

    Sanded down ready for dip

    In the bath

    After 10 min in the bath

    washed off in water, scrubbed with #000 steel wool

    side by side with Tanaka 190mm gyuto unetched

  2. #2
    Senior Member Baby Huey's Avatar
    Join Date
    Aug 2013
    Houston, Tx
    Looks nice. Good job.

  3. #3
    Senior Member CrisAnderson27's Avatar
    Join Date
    Jun 2013

    Barkeeper's Friend is acidic. It will remove some of the oxides from the etch, but leaves an interesting satin grey finish of its own, along with some of the etch left from the lemon juice/vinegar/ferric/whathaveyou. I use Windex as a neutralizer for vinegar OR ferric chloride...and rub the blade down with Barkeeper's Friend while the Windex is still on it. After that I rinse with water, and etch again if the finish isn't strong enough.

    Hope that helps!!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts