Results 1 to 8 of 8

Thread: How do you clean your heavy aluminum baking pans?

  1. #1
    Senior Member GeneH's Avatar
    Join Date
    Mar 2013
    Location
    Minneapolis Area Minnesota
    Posts
    135

    How do you clean your heavy aluminum baking pans?

    My wife has large heavy baking pans and we are getting some of that carmalized coating on them. How do you clean yours without steel wool or taking off the oxidized layer?

  2. #2
    daveb's Avatar
    Join Date
    Mar 2012
    Location
    Just outside Tampa
    Posts
    1,507
    Are you asking about alum 1/2 sheet pans by nordicware etc? If its gunked up beyond easy, heating some water in the pan and a green pad gets most off. I've used wd-40 and green pad on bad skillet gunk when all else has failed. Should do job on baking pans. Wash well after. If Mrs Gene is still not happy, new pans are only 10 bucks each.
    Dave
    Older and wider.

  3. #3
    Senior Member
    Join Date
    Feb 2013
    Location
    bay area, california
    Posts
    586
    i really dont worry so much about the gunk. i do my best at the sink. i'll even take some BKF to it..the alum will oxidize again. after a few years, when they look like total crap, i'll toss them into a recycle bin and buy new ones. they are $11 at my restaurant supply store.

  4. #4

    ecchef's Avatar
    Join Date
    Feb 2011
    Location
    In the Village.
    Posts
    3,545
    Oven cleaner.
    Though I could not caution all I still might warn a few; Don't raise your hand to raise no flag atop no ship of fools. - Robert Hunter

  5. #5
    Senior Member
    Join Date
    Jul 2013
    Location
    Canada
    Posts
    711
    I've put mine through the self-clean cycle in my oven. Works great.

  6. #6
    Senior Member GeneH's Avatar
    Join Date
    Mar 2013
    Location
    Minneapolis Area Minnesota
    Posts
    135
    Oven cleaner and WD-40 sounds kinda toxic... I just asked "Mrs. Gene" (heh) these are the quarter sheet commercial pans. Had them a while, about $6 back then from a restaurant supply store. Not as much $$ as I thought, which is a good thing. She doesn't want to take off that smooth finish. Very hot water and a green scrubbie sounds good as long as I can keep from burning myself....cuts are bad enough, I don't want burns..

    :-)

  7. #7
    I don't, my wife does.
    "Those who say it can't be done are always pasted by those doing it"

  8. #8
    Senior Member GeneH's Avatar
    Join Date
    Mar 2013
    Location
    Minneapolis Area Minnesota
    Posts
    135
    And the answer is... a little boiling water and a blue scrubbie sponge w/soap. The trick was keep refreshing the water 'cause it cools and using a small hand brush to push the sponge around w/o burning myself. Worked well enough and didn't remove any oxide or scratch the alu. Also turns out (yep, you were right) these are not really that expensive when purchased from a kitchen supply store.

    Thanks folks!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •