Only if I had just bought a $20,000 Kramer on eBay that needed sharpening.
You get a knife 'sharp' is 3 min and even if you charge $5 per knife, you can make $100 an hour (mathematically speaking). Not bad at all.
I wont' be surprised if the design is cloned and used in some 'pro' sharpening setup. I for one am going to bookmark this page.
If I were to suggest an improvement to Mr. Jackson it would be to add a VFD to his setup and tune up the components so the grinder doesn't make as much noise. Too much racketing noise for my taste.
"All beauty that has no foundation in use, soon grows distasteful and needs continuous replacement with something new." The Shakers' saying.
If my KKF Inbox is full (or not), please contact me via Email: email@example.com
Hmm, I was looking at getting a grinder/polisher for some knife handles anyway. Now I know I can attach some pulleys and some aluminum oxide belts and make a sharpener too. I'm SOLD!
Its not a new design. The local sharpening shop has been using and selling the same design for years.
They charge the same for a higher quality system. They can sharpen a knife in less than 3 minutes. They do enough business in knives and sharpening to have 3-5 employees.
"Insanity: doing the same thing over and over again and expecting different results." --Albert Einstein