I like to try to make stuff. Doesn't always matter if I am successful but I enjoy trying to do something creative. If it turns out well and is useful that is a plus. I am not a good one for following directions so I tend to wing it and hopefully learn as I go along. Usually I figure out what not to do first. This project is an example. As I go along I will figure out what to do differently, what jigs to make and the tools to use so the next one I make will turn out better. Who knows, maybe I will eventually get good at this.
A short while ago my back was acting up so I had to find an old garage sale cane to keep from falling on my face. My wife asked "couldn't you make something like that?" So here is my first attempt. It won't get all the way finished today but here is the start of the project.
This photo shows the cane I am using as a reference and some scrap wood I will be using. This style of cane was comfortable for me and was very usable.
Did a rough outline of the handle.
Drilled both pieces so I could use a dowel to strengthen the joint between the 2 pieces. (Note to self; make a couple jigs and use correct drill bit.) Using a hand held drill was not a good idea.
Cut out rough handle shape. (Note to self; don't use old dull bandsaw blade.)
Glued handle to the shaft. (Note to self; make a clamping jig.)
Evened up the sides.
Next I will need to even up the edges and clean up the profile of the handle. After that I will be using a router for the shaping.