Quantcast
Mixing strop compounds
+ Reply to Thread
Results 1 to 7 of 7

Thread: Mixing strop compounds

  1. #1

    JohnnyChance's Avatar
    Join Date
    Feb 2011
    Location
    CT
    Posts
    3,028

    Mixing strop compounds

    I made a couple strops, and on one of my balsa strops I have a compound that I am not wild about. I hardly ever use it anymore. Any problem with putting another compound right over it? The compound currently on it is the finest grained compound I have, so the new stuff on top of it would be a lower grit.

    Figured might as well try it, better than having a strop I never use.
    "God sends meat and the devil sends cooks." - Thomas Deloney

  2. #2

  3. #3

    Join Date
    Apr 2011
    Location
    Oslo
    Posts
    1,428
    How thick is your balsa? If its so much of a pain for you just sand it out.
    Or just mix it. Would it really matter?

  4. #4

    JohnnyChance's Avatar
    Join Date
    Feb 2011
    Location
    CT
    Posts
    3,028
    Right, what do I have to lose other than a 1/4 teaspoon of compound?

    Quote Originally Posted by bieniek View Post
    How thick is your balsa? If its so much of a pain for you just sand it out.
    Or just mix it. Would it really matter?
    1/4". Not sure if it would matter. Gonna find out! Sanding I am weary of, even if it was thicker, because I do not want any particles from what I am sanding with to lodge themselves in the balsa.
    "God sends meat and the devil sends cooks." - Thomas Deloney

  5. #5
    Senior Member

    SpikeC's Avatar
    Join Date
    Feb 2011
    Location
    PDX
    Posts
    3,773
    Quote Originally Posted by JohnnyChance View Post
    Right, what do I have to lose other than a 1/4 teaspoon of compound?



    1/4". Not sure if it would matter. Gonna find out! Sanding I am weary of, even if it was thicker, because I do not want any particles from what I am sanding with to lodge themselves in the balsa.
    This is a very good point. If you do wish to remove the surface of the balsa, a card scraper would be just the ticket.
    Spike C
    "The Buddha resides as comfortably in the circuits of a digital computer or the gears of a cycle transmission as he does at the top of a mountain."
    Pirsig

  6. #6

    Join Date
    Mar 2011
    Location
    Rockport, TX
    Posts
    4,892
    1. Flip the Balsa over?
    2. Buy a new balsa, it's like $2.
    3. You can sand it down. I cleaned mine up lightly with 2500 grit sandpaper before I loaded them.
    4. Just cover it up. The old compound will just make tinier scratches, and their impact will be obscured by the bigger particles.

  7. #7

    JohnnyChance's Avatar
    Join Date
    Feb 2011
    Location
    CT
    Posts
    3,028
    The balsa is glued to a wooden base. I have more balsa and more bases, but I would like to make this one useful again. I am sharpening today, I will try adding new compound to it.
    "God sends meat and the devil sends cooks." - Thomas Deloney

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts