Results 1 to 6 of 6

Thread: Fast finish on a knife.

  1. #1

    Fast finish on a knife.

    I decided to learn to sharpen properly, and I think of using the technique Korin_Mari said - creating and edge and crushing it, rinse, repeat. Because I still wobble a lot the knife is in terrible visual shape.

    Is there a fast finish that could be restored so i could see where the new bevels (and scratches) are - painting the whole side of the knife with sharpie comes to mind. But I prefer not to.

  2. #2
    Senior Member
    Join Date
    May 2011
    Location
    Boston
    Posts
    776
    if you're practicing on a cheap carbon steel knife, a light etch in ferric chloride would turn the blade dark in a few seconds. Just have to neutralize it afterwords.

  3. #3
    Carbonext will be my practice knife. It is not very reactive. But that is a extremely good idea.

  4. #4
    Can it possibly take more than 10-15 seconds per side to Sharpie a bevel? Also, comparing the reactivity of my Ichi TKC to my Watanabe, I'm not sure Ferric acid and the CarboNext is going to be your answer. FWIW - I've been freehand sharpening for 10 + years, I still wobble some, and the best cure is slowing down

  5. #5
    The problem is that there are some very polished areas on the face of the knife, where I have applied too much pressure at too low angle, too high on the bevel. As if having faux bevel above the secondary bevel (IIRC the one that forms the edge was secondary, newbie on knives). So I need to restore is to some form of matte finish.

  6. #6
    Senior Member Benuser's Avatar
    Join Date
    May 2011
    Location
    Amstelveen, The Netherlands
    Posts
    2,372
    Medium sandpaper, P400, or coarse (brown) ScotchBrite, both along the edge

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •