Quantcast
Custom kiritsuke gyuto - Page 3
+ Reply to Thread
Page 3 of 3 FirstFirst 123
Results 21 to 28 of 28

Thread: Custom kiritsuke gyuto

  1. #21
    Dave Martell's Avatar
    Join Date
    Feb 2011
    Location
    Fleetwood, PA
    Posts
    9,285
    Dang man, you really thinned it down, but did you mean 0.049 at the edge?

  2. #22
    Senior Member

    Join Date
    Feb 2011
    Location
    San Diego, CA
    Posts
    4,221
    Those are some more exciting dimensions depending on exactly where you're taking them.

  3. #23

    HHH Knives's Avatar
    Join Date
    Apr 2011
    Location
    Michigan
    Posts
    3,633
    Dave, Nope, I mean .49mm best I can tell with digital calipers. Im getting a average thickness of .50mm along the whole length of the blade above the bevel.

    tk59. Figured these numbers would be more to your liking..
    I measured the blade like this. first set of numbers are at the spine, second set is measures near halfway point on the blade.. and last set is 1.5 to 2 mm above the cutting edge.
    I measured in 3 spots for each area. first above the heel. then midway point of the blade/length and last about 1/4" behind the tip
    I plan on adding new pics today. just need to do a bit more finish work to the blade faces.

    This knife is a different monster now! Its just screaming sharp and begin to cut somthing! Its much lighter and the balance point is now right about at the middle of the HHH...

    Thanks again guys.
    Randy

    Inspired by God, Forged by Fire, Tempered by Water, Grounded by Earth, Guided by the spirit.. Randy Haas

    240mm Stainless Gyuto!!

  4. #24

    HHH Knives's Avatar
    Join Date
    Apr 2011
    Location
    Michigan
    Posts
    3,633
    A few pics..


    Inspired by God, Forged by Fire, Tempered by Water, Grounded by Earth, Guided by the spirit.. Randy Haas

    240mm Stainless Gyuto!!

  5. #25

    JohnnyChance's Avatar
    Join Date
    Feb 2011
    Location
    CT
    Posts
    3,000
    Looks good! So was this an experimental project or an order for a customer?
    "God sends meat and the devil sends cooks." - Thomas Deloney

  6. #26

    HHH Knives's Avatar
    Join Date
    Apr 2011
    Location
    Michigan
    Posts
    3,633
    Johnny, This one is a experimental test knife to test out the new butchcarta.. (well "new" to me at least) and second to test out the kiritsuke blade profile...

    Inspired by God, Forged by Fire, Tempered by Water, Grounded by Earth, Guided by the spirit.. Randy Haas

    240mm Stainless Gyuto!!

  7. #27
    Senior Member tgraypots's Avatar
    Join Date
    Apr 2011
    Posts
    530
    I like it.
    Tom Gray, Seagrove, NC

  8. #28

    HHH Knives's Avatar
    Join Date
    Apr 2011
    Location
    Michigan
    Posts
    3,633
    Thanks you sir.

    Inspired by God, Forged by Fire, Tempered by Water, Grounded by Earth, Guided by the spirit.. Randy Haas

    240mm Stainless Gyuto!!

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts