Process video.

Kitchen Knife Forums

Help Support Kitchen Knife Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
My camera has never been so filthy as after this one 😂
Fun day 😎
 
When did you switch to the stamp? Vast improvement over an etched logo in general in my opinion.
 
Yes the stamp is great :) I have used it for my carbon steel knives since last summer I think. For stainless I still have many ready heat treated blades that I etch the logo on.
 
The stamp is "present" where as an etch always feels fleeting to me unless you go deep. Awesome stuff regardless.
 
etching logo is one of few processes I have a bit of dislike for. If going deep it tends to look wonky in the edges, I do some happy medium deep, seems to last through many refinishings, but looses the black.
 
Yeah your logo requires a crisp edge. What about laser etch? I spec that can be much deeper and more controlled than electro etch.
 
I would worry the laser etch is less deep, and I think that would also loose the black with refinishing.
 
Back
Top