Well, it would have both. I drew out a sheath designfor it last night, going to window in some stingray skin behind some tooled leather. Should be pretty cool, if i don't screw up lol.
Well, it would have both. I drew out a sheath designfor it last night, going to window in some stingray skin behind some tooled leather. Should be pretty cool, if i don't screw up lol.
Thanks TK. I just might do that, handle is pretty long as it is, 154 mm And dimensions are as follows(for now) Height at heel:23.2mm, width at heel: 21.4mm, Height at butt: 26.05mm, Width at butt 21.35. So it appears that i have a little bit of shaping to do lol. Handle weighs a whopping 176 grams right now, with the blade only coming in at 181 grams..... I suppose that needs to change to get the handle a bit under the blade. Maybe i will lose 6-7mm on length, easy to trim the buttcap lol. And also thin the front of the handle out to about 19 ish mm. Hopefully i can drop 25-30 grams off of it.
What brand epoxy did you use to hold so many different materials together?
I used 60 minute loctite, and JB weld. The blade is not attached yet, but i will use acraglas to hold that in. With the way everything interlocks, it is like a puzzle. Once the blade is mounted and the corbies are put in, it will be next to impossible for anything to move. Engineering the handle construction was what took me so long to finish it lol.
I am hoping to have the handle reshaped and completely finished today. Corbies are ready to go, and handle is partially reshaped. Thinking i need to take a little bit more off before i polish it again. Pics in a little while, getting ready to go to the dentist :/
tap! tap! tap! well?
I haven't lived the life I wanted, just the lives I needed too at the time.
LOL! Sorry. Handle is mid redo, had a friend drop it on the concrete floor and broke the handleWe are going full musk ox this time. No more rubix cube stuff....too damn hard lol.
Man, I hope you managed to save some of that Musk ox for a spacer or something. That stuff was really nice!