400lbs Recycle Bin Anvil stand

Miura knives
Kitchen Knife Forums

Help Support Kitchen Knife Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
jessf

jessf

Senior Member
Joined
Jan 10, 2016
Messages
869
Reaction score
6
Dry weight of the concrete is 400lbs so i estimate 500lbs or more when hydrated and cured. Carriage bolts at the bottom and some welded wire mesh is all it takes.







I sunk two layers of welded wire mesh into the concrete as well.
 
Photobucket said, "**** y'alls photos."
 
That's awesome thanks. Millions of tutorials are being held hostage by photobucket rendering them utterly useless. Now to find a mobile hack.
 
I’d call that a success.



Just need to grind down the ridges in the middle and the anvil sits flat. The ridge around the perimeter of the top will keep tools from rolling away.

 
It’s about 20” high. I’d say it’s a little on the short side, ill likely put it on bricks or 2x4s to get an extra 1.5” or so. Depends on the height of your anvil as well. Were i to do it again i’d cut plywood trapezoids to match each face of the bin and slip those shapes into the collar i made to help keep the bin from bulging.
 
You must log in or register to reply here.

Latest posts

Back
Top