Lookee what I've got coming tomorrow....

[Marko Tsourkan]

For a moment I thought it was fro Travis Wuertz. Very similar principle for fastening.
The dust collection container is super neat!

M

[Burl Source]

I am guessing you have had some time to play with the new toy,
....I mean slave away working with the new grinder.
How do you like it?

[Dave Martell]

I am guessing you have had some time to play with the new toy,
....I mean slave away working with the new grinder.
How do you like it?

Guess what? I haven't touched it yet - I've been on the belt just looking over at it once in awhile.

[Burl Source]

Too often when I get a new toy, I mean tool, I hesitate to start using it.
I get set in old routines and procrastinate using the new tool that will cause me to have to change my routine.
But then when I finally start using the new one and get used to it I look back and say to myself "I should have been using this weeks ago".

[jmforge]

Nice!! Yes, a miter slot would be good, but just having the table/workrest is a drastic improvement IMO. So is your next one going to be the horizontal setup?

[apicius9]

Too often when I get a new toy, I mean tool, I hesitate to start using it.
I get set in old routines and procrastinate using the new tool that will cause me to have to change my routine.
But then when I finally start using the new one and get used to it I look back and say to myself "I should have been using this weeks ago".

Just did the same thing with a simple 12" disc sander I had picked up a while ago. It just sat there with plastic over it so it doesn't get dusty. Now that I started using it, life has become yet a little bit easier.

Stefan

[PierreRodrigue]

Just finished wireing up the motor and VFD, and the confirmation came that the tool rest has shipped.

[Dave Martell]

Oh yeah - congrats Pierre!

[jmforge]

The new tool rest setup means that it is actually more imperative that I buy one of those disc grinders soon. I want to try to split the output from my current VFD or just put plugs on the output and on each motor so I can save a few shekels.

[Dave Martell]

Well I finally got some time in on this new set up and yeah the table/work rest does help a lot for some things and so far I have no regrets.

Pierre, did yours come in yet?