Marko Tsourkan
Founding Member
- Joined
- Feb 28, 2011
- Messages
- 5,005
- Reaction score
- 34
I have a few pieces of cow horn that I got from a vendor in Europe. The length 1" is a bit short for my knife handles and quality is lower than I would like for premium handles, however it is still a pretty decent quality horn that is hard to get and will be priced accordingly (moderately).
So, I have been thinking what to do with it. The length and diameter makes it suitable for cleaver handles.
Is there an interest for these? If I make them, they would have to be same size, self-installed or sent to Dave for installation.
I have about 15 pieces of 1x1.5"(diameter) cow horn.
M
So, I have been thinking what to do with it. The length and diameter makes it suitable for cleaver handles.
Is there an interest for these? If I make them, they would have to be same size, self-installed or sent to Dave for installation.
I have about 15 pieces of 1x1.5"(diameter) cow horn.
M