Quantcast
Can this be fixed? - Page 2
+ Reply to Thread
Page 2 of 4 FirstFirst 1234 LastLast
Results 11 to 20 of 36

Thread: Can this be fixed?

  1. #11
    Senior Member
    Join Date
    Mar 2011
    Location
    Newport Beach
    Posts
    495
    This photo made me so sad when I saw it it my email. I was a little confused at first because the second photo didn't download. But I could see a small bump on the edge in the first photo.... Then the second photo downloaded on my phone and I realized it was over for my knife.

    -Chuck

  2. #12


    Bill Burke's Avatar
    Join Date
    Mar 2011
    Location
    Lives in the mountains near Boise, Idaho.
    Posts
    488
    If it mAkes you feel better chuck I have another forged out now

  3. #13

    Join Date
    Mar 2011
    Location
    Rockport, TX
    Posts
    4,892
    It ain't over! I'd seriously consider taking this instead of a working knife. That is crazy cool. What a conversation piece!

  4. #14

    HHH Knives's Avatar
    Join Date
    Apr 2011
    Location
    Michigan
    Posts
    3,630
    HOLY SMOKES!! thats WILD Bill! I have never seen anything quite like that B4.

    Almost makes me feel a little better about the micro chipping problem with my stainless san mai test blade. Im sure your new blade will work out better..

    Much respect,
    Randy.

    Inspired by God, Forged by Fire, Tempered by Water, Grounded by Earth, Guided by the spirit.. Randy Haas

    240mm Stainless Gyuto!!

  5. #15


    Bill Burke's Avatar
    Join Date
    Mar 2011
    Location
    Lives in the mountains near Boise, Idaho.
    Posts
    488
    I am not sure what happened on this. Everything was fine after hardening. Then into cryo and when it came out there was a crack on the spine. As it sat on the bench ping tink crack it started to split And I am not sure if it's done yet.

  6. #16

    PierreRodrigue's Avatar
    Join Date
    Mar 2011
    Location
    Alberta, Canada
    Posts
    1,747
    Wow! The stresses must be insane!


    Feel free to visit my website, http://www.rodrigueknives.com
    Email pierre@rodrigueknives.com

  7. #17


    Bill Burke's Avatar
    Join Date
    Mar 2011
    Location
    Lives in the mountains near Boise, Idaho.
    Posts
    488
    this knife ended up splitting clear from tip to tang and edge to spine, almost perfectly in the middle.

  8. #18
    Senior Member
    Join Date
    Mar 2011
    Posts
    270
    A new technique for creating single-beveled lasers in half the time?

  9. #19

    Join Date
    Dec 2011
    Location
    Forsyth, MT
    Posts
    9
    just add more flux, that stuff is like glue you know.

  10. #20

    Join Date
    May 2011
    Location
    Top of Georgia
    Posts
    1,218
    JB Weld.

    -AJ

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts