Don Nguyen
Senior Member
- Joined
- Oct 17, 2011
- Messages
- 898
- Reaction score
- 139
I spent a good amount of time these past few months studying profiles. I tried to make it as sleek as possible while maintaining good knuckle clearance.
The oxidation at the tip is from when I held it up to the piece I was forging. From the heel it has about 10cm (4") of almost dead flat edge.
Blade length is 240mm
Overall height at heel is 60mm
Knuckle clearance at heel is 45mm
Handle length 140mm (5.5")
Too flat?
The oxidation at the tip is from when I held it up to the piece I was forging. From the heel it has about 10cm (4") of almost dead flat edge.
Blade length is 240mm
Overall height at heel is 60mm
Knuckle clearance at heel is 45mm
Handle length 140mm (5.5")
Too flat?