http://www.tsourkanknives.com/index....ves-order-form
Any suggestions to improve it?
Thanks!
http://www.tsourkanknives.com/index....ves-order-form
Any suggestions to improve it?
Thanks!
https://www.facebook.com/ST-Machine-...3629542674267/
If my KKF Inbox is full (or not), please contact me via Email: anvlts@gmail.com
Steel choice?
k.
Danny 'Zwiefel' Owen - 1971-2016 Moderator and Knife Knut for Eternity. RIP
Yep, thanks!
https://www.facebook.com/ST-Machine-...3629542674267/
If my KKF Inbox is full (or not), please contact me via Email: anvlts@gmail.com
Maybe an option for other in the knife length. Then customer can put length in the describe below section. That way they don't have to choose a length other than desired before describing.
Good Call!
https://www.facebook.com/ST-Machine-...3629542674267/
If my KKF Inbox is full (or not), please contact me via Email: anvlts@gmail.com
I thought you had a San Mai option? Other than that, perhaps a graphic of a completed knife at the top for a little POP.
I am not going to do san mai at this time. Maybe at a later time.
Thanks, Matt -
M
https://www.facebook.com/ST-Machine-...3629542674267/
If my KKF Inbox is full (or not), please contact me via Email: anvlts@gmail.com
Looks pretty good from here, Marko. Mokume is spelled 'mocume' under Handle Endcap*, but other than that it looks good.
Corrected, thanks -
https://www.facebook.com/ST-Machine-...3629542674267/
If my KKF Inbox is full (or not), please contact me via Email: anvlts@gmail.com
Maybe include some general information on policies even if they appear elsewhere on the site. Estimated delivery, as best as possible; return policy if any (doubt you would have much of this); payment methods; deposits. You have addressed much of this to forum members, but 'forum foreigners' may not know as much about your knives as they should.
~s
Everywhere you go, there you are.