Results 1 to 7 of 7

Thread: How to Sharpen a Gyuto

  1. #1
    Senior Member ThEoRy's Avatar
    Join Date
    Feb 2011
    Location
    Central Jersey
    Posts
    3,304

    How to Sharpen a Gyuto

    This comes up every now and again so I made a new video on the subject. Question or comment below.

    Starting this harvest I'm a starving startling artist/
    Lyrical arsonist it's arduous spitting this smartest arsenic/

  2. #2
    daveb's Avatar
    Join Date
    Mar 2012
    Location
    Just outside Tampa
    Posts
    1,980
    Like it.
    Dave
    Older and wider.

  3. #3
    Senior Member larrybard's Avatar
    Join Date
    Dec 2013
    Location
    Philadelphia
    Posts
    477
    Rick, Thank you. Do I understand correctly that due to the geometry of this gyuto you are making the angle of the edge on one side twice the angle of the other side? When you sharpen you hold the handle in your right hand, but when you "blend" on the 5k and when you strop with trailing strokes to deburr you shift hands for each side. You do that because you just happen to find it more comfortable?

  4. #4
    Senior Member ThEoRy's Avatar
    Join Date
    Feb 2011
    Location
    Central Jersey
    Posts
    3,304
    Yezzir the stropping motion is easier for me in both hands while I adapted the 1 hand sharpening technique to prevent getting **** all over my handles. The angle is def. lower on the front though how much I can't say.
    Starting this harvest I'm a starving startling artist/
    Lyrical arsonist it's arduous spitting this smartest arsenic/

  5. #5
    Senior Member larrybard's Avatar
    Join Date
    Dec 2013
    Location
    Philadelphia
    Posts
    477
    Sorry, I didn't mean one angle might be twice the other; I meant 50% greater (e.g., 8 degrees and 12 degrees).

    It's a long time since I took trigonometry, so I might be mistaken, but it seemed to me that if on one side you were elevating the spine by a certain height, and the other side 50% higher -- e.g., by the widths of two pennies and three pennies, respectively -- that the difference would correspond to a 50% change in angle.

  6. #6
    Senior Member
    Join Date
    May 2011
    Location
    Boston
    Posts
    849
    Wow, those are some acute angles. It's been a while since I've done trig as well, but assuming a 48 mm blade height and a penny width of ~ 1.5 mm, I'm calculating an angle of 3.5 degrees on the right face and 5.4 on the left. sin (x) = (#pennies*penny width)/blade height <- am I doing this right?

  7. #7
    Senior Member Benuser's Avatar
    Join Date
    May 2011
    Location
    Amstelveen, The Netherlands
    Posts
    2,515
    That's correct. If you have the pennies disappearing under the blade instead of being next to it, it becomes all much more reasonable. And you should add the blade's slope to have an idea what the angle is between stone and blade's axis.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •