PierreRodrigue
Senior Member
- Joined
- Mar 1, 2011
- Messages
- 1,974
- Reaction score
- 1
Here is a bit of a WIP on a little knife I am working on, comments welcome!
Starting materials. Bog oak, mammoth tooth, maple dowell, fiber spacers, and a hunk of black buffalo horn
Handle materials assembled, at this point the tang slot is in place, and the dowel is inside the handle, to provide an extra mechanical bond.
Next, removing the surplus on the 36 grit belt.
Squaring the handle.
Setting the bevels.
Next the sanding smooth, and sealing the mammoth and horn.
Starting materials. Bog oak, mammoth tooth, maple dowell, fiber spacers, and a hunk of black buffalo horn
Handle materials assembled, at this point the tang slot is in place, and the dowel is inside the handle, to provide an extra mechanical bond.
Next, removing the surplus on the 36 grit belt.
Squaring the handle.
Setting the bevels.
Next the sanding smooth, and sealing the mammoth and horn.