I am still weeding out my J-nat collection. Here is the second round of J-nats. I decided to put it in a new thread as the other thread was getting a little confusing with my price drops and the things that had already sold. So, mods can delete the old one if necessary.
I did not provide bevel Finish Pictures for Knives, but if you are interested I would be more than happy to provide them Via PM.
All asking prices do not include shipping or paypal fees. If you do a bank transfer then I will cover the shipping.
Here is a set of J-nat Edge pro stones, asking $275 for the entire set. I am also willing to break up the set if anyone is interested in a single stone, see the prices beside each stone.
Stone List is as Follows from Most coarse to most fine (From Left to Right):
1“ Amakusa Red: Approximately 800 grit speed-finishes in the 1k range ($30)
1.25” Aoto- There are 2. Approximately 3k grit. ($35 each)
2” Belgian Blue (This one has a small cut at one end but does not affect sharpening) ($40)
1” Tsushima Nagura: Approximately 5-7K finish ($40)
1” Hideriyama Namito (There are 2 of these and are extra thick)-Excellent 10K Finish ($40 each or $60 for the Pair)
2” Hideriyama Renge Suita: Finishes 8-10K ($85)
2” Nakayama Kiita to Light Asagi- 10-15K Finish with an exceptional edge ($105)
1.5” Ozuku Asagi (Traveler Stones bought from Maxim): unmounted to an edge pro blank- Spectacular 15-20K finish. Not lapped but tested, will lap and prep for work upon request. ($80)
Ozuku Pure Asagi (8”x3”x1.25”) ($200.00): This is a hard stone (Lv 4.5)- If used correctly provides a good final finish to kitchen knives- Can also be used as a pre-polisher for straight razors. None of the lines you see can be felt and do not scratch. Stone is already sealed and lapped.
Ozuku (8”x3”x1.25”) ($190.00): This is a hard stone (Lv 4)- If used correctly provides a good finish- Final finisher for knives and pre-polisher for straight razors. Stone is already sealed and lapped.
Ozuku San, Pure Mizu Asagi LV5+ ( 8.25” x 2.25” x 1”) ($240)
Awesome final finisher for Straight Razors, with original stamps. Not much else to say!!!
San Aoto (200mm x 40mm x 40mm) (Sealed and Lapped-$90, Not sealed/lapped $80). (Together $155)
These are excellent middle stones, 3-5k finish. Can be used with knives or straight razors. Both of these stones are very even in texture and grit, and are quite a bit harder/finer than your “average” aoto. One stone is sealed and lapped (the one I am holding), while the other is not sealed or lapped. You can find a full write up with finish blade photos on the aoto shootout in the review section.
Very Large Hakka With Renge Patterns (LV 2.3-3) (205mmx 75mm x 45mm)
This stone is an absolute marvel, with tons of renge, and absolutely no visible inclusions. It produces a luxurious and thick mud quite easily and is very even in texture and grit. Good as a finisher in its own right, but excellent as a pre-finisher for an Atagoyama or Ohira Renge Suita. This stone is very fast for it’s fineness. Comes with a wooden storage box. You can find a full write up of this complete with Photos and knife finish on my hakka renge review.
Ohira Renge Suita (LV 3.5) (8” x3” x1.5”) (Cream Colored) ($695)
There is not much to say about this stone except WOW!!!!! It is one of the best final finishers I have come across for knives and can be easily used as a prepolisher for straight razors. I am selling this one only because I have 3 others. It is hard for a Suita and does not produce mud very easily, however it is incredibly fast and fine, a combination of features not often seen. In my opinion a true a gem!
Thanks For Looking,