Koa Handle

Kitchen Knife Forums

Help Support Kitchen Knife Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Hattorichop

Senior Member
Joined
Jul 13, 2011
Messages
575
Reaction score
1
Here is a handle I have for sale. It is a piece of crushed velvet Koa from Mark at Burl Source.
I used some brass spacers to break up the Koa and too give the appearance of there being a ferrule and an end cap.
I like slender handles and I would not hesitate to put this on a 240mm knife but it may be more appropriate for a 210 or even a 190mm nakiri or santoku.
View attachment 9406
View attachment 9407

I am asking $120 shipped or $135 If you would like it mounted.

Thanks for looking.
Karl
 
Very cool handle.
I really like the different size spacers and the way the brass goes with the koa.
 
please tell me the handle's size L+tip/end w x h
 
Thanks for the positive feed back everyone. Comments like these are much appreciated and will help me continue making stuff.

The handle is 5.5"long.
Ferrule is 5/8 x 13/16.
Butt is 3/4 x 15/16.
 
This one might be headed to Austrilia!

Thanks for looking.
Karl
 
This is fantastic knife handle; I hope it is something you will both continue with...good luck!
 
Back
Top