Page 1 of 2 12 LastLast
Results 1 to 10 of 14

Thread: Boogered-Up Makers Mark

  1. #1

    Boogered-Up Makers Mark

    I practiced a dozen times on some 304 and not once did I have tape marks etch in on me.I etch my first blade and have two deep marks at the tape line.Is this from to much fluid on the pad??It SUCKED having to take the blade back to the belts and ruin the mark.

  2. #2
    I think the Mark is awesome, nonetheless.

    Maybe use a smaller pad.

  3. #3
    Das HandleMeister apicius9's Avatar
    Join Date
    Feb 2011
    Honolulu, HI
    What a relief, from the title I thought you wasted some fine whisky...


  4. #4
    I like your mark too.

  5. #5
    Are the etched lines at the ends of the stencil?

  6. #6
    Nice mark Mario!
    Tom Gray, Seagrove, NC

  7. #7
    Quote Originally Posted by Rottman View Post
    Are the etched lines at the ends of the stencil?

  8. #8
    Try a bigger stencil or a smaller pad, obviously the tape didn't isolate as well as the stencil film.

  9. #9
    I did cut the stencil to small......I guess I will have to watch more you tube vids.

  10. #10
    Here is a trick I figured out. Get some good packing tape, pull off a piece, use an exact knife to cut a suitable sized hole in the tape, slightly bigger than your logo, center your logo, and press the tape on good. do the same on the reverse side, this greatly increases the size of your stencil, the tape works great as a moisture dam to keep the solution from going to unwanted areas. Trim it up as needed.

    Feel free to visit my website,

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts