Zwiefel
Senior Member
- Joined
- Jul 22, 2012
- Messages
- 3,294
- Reaction score
- 6
Nice job! That is a bizarre tip chip. Don't be afraid next time to grind the spine down a little to keep the tip height the same. Of course, on this knife, and with this strange horizontal chip, it hardly matters.
Anybody else trying to figure out what kind of knife this is? I've never seen this profile with the German makers.
+1
with sandpaper in the P120-700 I cut a straight line from the spin at 30 to 60 degree til I reach the edge. Depending on my mood I decide to restore the spine curve or not. If the tip is too low that may be easily corrected later on with sharpening.
Enter your email address to join: