noj

Got it, thanks; that's what I thought originally. Will hive it a bit more use before I do major surgery. It still likes to wedge more...

Alas, less rosy picture than that. Sorry the for the confusion - when I say height above I mean as measured from edge to spine more or...

OK, that's very different from my assumption, if I understand you correctly. It sounds like the low spot measurement is from a flat...

Thanks for the reply and diagrams; very helpful. I will have to try this when it comes time. I like the fact that you have two...

Personally, I'd suggest using the knife is for some time. Use and sharpen it enough that it eventually needs a thinning and then tackle...

Tip. There was originally already more core exposed at the tip on this side. I did quite a bit of work here, and on both sides, to...

Heel overgrinds. The RHS is as bad as originally depicted (with the big "L" magic marker). All I did was smooth things a little with a...

Profile curvature:

I am looking for additional advise before doing more work. I have more photos, observations, and (crude) measurements. The knife has a...

Oops, I forgot to answer your first question - the other side. The other side has a lot of exposed core. Not my doing either. It also...

Thanks for the reply, and details. I have tried to be careful of not working directly over the problem spots - and there were several...

I'd ideally like to reach the heel, but maybe just light sandpaper (for appearance), and sharpen? Other ideas welcome. I tested it on...

Background .. It's an Iron clad Wat that needed a tune-up to be useful. My first goal was to make the useful part be for the kitchen...

I don't know if my SS's are "different", but they actually bend when they get wet. Mine need 5-10 min soak to they stop changing shape...

Knife from @thebradleycrew .. thx!