Latest knife, Damasteel and Ambonya.
Full tang construction with damascus pattern visible around the perimeter of the handle. Hardened to 62 HRC
Blade length: 21 cm
Total length: 32 cm
Blade height: 4,8 cm (at heel)
Spine width: 3,2 mm
Edge angle: 16°
I usually sand to 800-1200 grit but after that i polish the piece on four different buffring wheels with compounds going from 6,5 micron down to 0,1 micron. This renovera all scratches from sandning and leaves a perfect mirror polish before etching
Is there any interest in custom Damasteel Nakiris like the one pictured below on the forum? I can make two more in the same pattern from the steel that I have on hand. Send me an message if there is any interest.
Approximate pricing is around $ 600-650. Lead time at the moment from...
Here is my latest finished chef knife. An 16 cm Nakiri in Damasteel and stabilized maple burl. The handle turned out really great! I wasn't certain that a blue handle would look good but the client insisted on one.
Checking to see if there is any interest in an Damasteel Nakiri.
Blade in stainless Damasteel, handle in stabilized Ambonya with bronze pins.
Se pictures for dimensions, hardness is 62 HRC
First a couple of ”beauty” shots
Spine thickness at handle
Spine thickness at front