Hello All,
This is the first of a run of 52100 blades I have in the work right now.
I've altered my profile just a bit for these. They've all go a much longer flat section that curves much more gradually before the midpoint than other blades I've made.
Thanks to @mengwong and the participants of the MagnaCut P/A thread (MagnaCut passaround [LIVE]) for the feedback that has lead to this alteration.
My maker's mark will be etched prior to shipping.
Thanks for looking!
This is the first of a run of 52100 blades I have in the work right now.
I've altered my profile just a bit for these. They've all go a much longer flat section that curves much more gradually before the midpoint than other blades I've made.
Thanks to @mengwong and the participants of the MagnaCut P/A thread (MagnaCut passaround [LIVE]) for the feedback that has lead to this alteration.
- Blade: 235mmx54mm 52100 (64hrc) 320 grit finish
- Neck: 17mmx18mm
- Handle: 130mm, tapering from 26.0mmx22.1mm to 22.1mmx17.8mm, burned oak, oil finished and waxed
- POB: 40mm from handle
- Spine: 2.63mm at the neck, 1.77mm at halfway, .65mm 1cm from the tip
- Grind: flat to convex RH bias
- Weight: 143 grams
- Relieved choil and spine
- Edge: <.05mm, .12mm @2mm, .38mm@5mm, .75mm@10mm measured at the midpoint.
My maker's mark will be etched prior to shipping.
Thanks for looking!
Attachments
Last edited: