Loong Workz
KKF Supporting Craftsman
Not trying to be misleading! This is just a project knife by me, 龍! That's the reason why I wanted it engraved on the other side of the knife.
Bought this knife a while ago, it was a little thick and I just somewhat decided I should thin and refinish the whole knife and now it's a convex laser(?). Kinda realised I didn't need anymore 210 Gyutos so I decided to sell it. C:
Specs:
F&F: Spine and choil Chamfered, 1k grit finish + Kasumi
Steel: White 1 + SS Clad
Length: 206mm
Height: 48mm
Weight: 158g
Handle: Dyed Stabilized Curly Maple in a Yo shaped configuration.
Thickness:
At handle: 2.9
At heel: 2.8
At midpoint: 2.0
At 1cm before tip: 1.6
Asking for 200USD + Shipping! I will chip in 15USD for shipping! Hit me up if you're interested!
Bought this knife a while ago, it was a little thick and I just somewhat decided I should thin and refinish the whole knife and now it's a convex laser(?). Kinda realised I didn't need anymore 210 Gyutos so I decided to sell it. C:
Specs:
F&F: Spine and choil Chamfered, 1k grit finish + Kasumi
Steel: White 1 + SS Clad
Length: 206mm
Height: 48mm
Weight: 158g
Handle: Dyed Stabilized Curly Maple in a Yo shaped configuration.
Thickness:
At handle: 2.9
At heel: 2.8
At midpoint: 2.0
At 1cm before tip: 1.6
Asking for 200USD + Shipping! I will chip in 15USD for shipping! Hit me up if you're interested!
