grinder died...

Discussion in 'Davis Knives' started by Mike Davis, Jan 15, 2013.

Help Support Kitchen Knife Forums by donating:

  1. Jan 15, 2013 #1

    Mike Davis

    Mike Davis

    Mike Davis

    Senior Member

    Joined:
    May 2, 2011
    Messages:
    1,521
    I first have to apologize to everyone waiting for knives, will be put about a week behind as my speed control(vfd) fried on my:whistling: grinder. I will be ordering a new one today, but will have to wait for shipping and figuring out how to wire it. I ended up having to finish the tang of a knife with a angle grinder and a 1x42....not ideal lol.
     
  2. Jan 15, 2013 #2

    l r harner

    l r harner

    l r harner

    Banned

    Joined:
    Mar 6, 2011
    Messages:
    548
    i remember burning mine up a few years ago (it was an open model) got a nema 4 this time and should be good to go for a long time. nice thing for me is that there is a place i can get them 30min form me so i jsut drove over and picked one up (thinking about getting a 2nd one for the bridgeport and to have on hand as a back up if need be
     
  3. Jan 15, 2013 #3

    Mike Davis

    Mike Davis

    Mike Davis

    Senior Member

    Joined:
    May 2, 2011
    Messages:
    1,521
    I ordered a Nema 4x this morning, so hoping to have the grinder up and running by the end of the week...Kinda left me high and dry not having it lol.
     
  4. Jan 16, 2013 #4

    Pachowder

    Pachowder

    Pachowder

    Well-Known Member

    Joined:
    Dec 22, 2011
    Messages:
    260
    i bet your wife is happy you will be spending a bit more time inside the house!
     
  5. Jan 16, 2013 #5

    Mike Davis

    Mike Davis

    Mike Davis

    Senior Member

    Joined:
    May 2, 2011
    Messages:
    1,521
    She works for a privately owned accounting firm. When she is on maternity leave, she does not get paid, so while she is off, it is my duty to make as much as possible to support our bills and feed our children. She is ok with me being outside :)
     
  6. Jan 16, 2013 #6

    Don Nguyen

    Don Nguyen

    Don Nguyen

    Senior Member

    Joined:
    Oct 17, 2011
    Messages:
    828
    Mike, it's time for you to finish your 3x132.
     
  7. Jan 16, 2013 #7

    Mike Davis

    Mike Davis

    Mike Davis

    Senior Member

    Joined:
    May 2, 2011
    Messages:
    1,521
    I bought the steel for it last week, gave the plans to my neighbor yesterday( killer fab guy) so i could get this rolling. It is time....
     
  8. Jan 26, 2013 #8

    Mike Davis

    Mike Davis

    Mike Davis

    Senior Member

    Joined:
    May 2, 2011
    Messages:
    1,521
    Finally got the new vfd installed yesterday, back in business!! I will be busting mu butt over the course of the next few weeks to get everything out the door.
     

Draft saved Draft deleted

Share This Page