Hello All,
This knife was formerly a full custom but owing to a rare crack forming in the quench, I had to make a shorter knife. This blade has more of a European/German profile than any I have made in a while with a high tip, a flat length of only 45mm near the heel, and a Denka inspired finger notch. The blade is very thin bte with good convexity and distal taper and the spine and choil areas have been relieved.
Blade: 232mmx 54mm AEB-L (63hrc) 320 grit hand rubbed finish
Neck: 17mmx18mm
Handle: Birdseye maple + walnut
POB: 50mm from the handle
Spine: 3.34mm at the neck, 2.53mm at halfway, .53mm 1cm from the tip
Grind: flat to convex RH bias
Weight: 150g
Relieved choil and spine
Edge: .15mm@1mm measured at the midpoint,
Asking $285 U.S+ $25 shipping. As always, if this blade is purchased in conjunction with another I will happily deduct $25 off of the price of the other blade.
Thanks for looking!
-Matt
This knife was formerly a full custom but owing to a rare crack forming in the quench, I had to make a shorter knife. This blade has more of a European/German profile than any I have made in a while with a high tip, a flat length of only 45mm near the heel, and a Denka inspired finger notch. The blade is very thin bte with good convexity and distal taper and the spine and choil areas have been relieved.
Blade: 232mmx 54mm AEB-L (63hrc) 320 grit hand rubbed finish
Neck: 17mmx18mm
Handle: Birdseye maple + walnut
POB: 50mm from the handle
Spine: 3.34mm at the neck, 2.53mm at halfway, .53mm 1cm from the tip
Grind: flat to convex RH bias
Weight: 150g
Relieved choil and spine
Edge: .15mm@1mm measured at the midpoint,
Asking $285 U.S+ $25 shipping. As always, if this blade is purchased in conjunction with another I will happily deduct $25 off of the price of the other blade.
Thanks for looking!
-Matt
Last edited:
