WTS MSicardCutlery -Matched Pair of 250mm 52100+Low Carbon Sab-Style Chef Knives W/Purple Heart Handles

Kitchen Knife Forums

Help Support Kitchen Knife Forums:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

MSicardCutlery

Full-time Knifemaker-Canadian Mazaki
KKF Sponsor
Joined
Feb 28, 2022
Messages
2,171
Reaction score
6,379
Location
Canada
Hello All,

Here I have two beauties up for grabs. A matched pair of low carbon san-mai 52100 cored chef knives in my Sab style pattern. Both feature oil finished purple heart handles that exhibit some curly chatoyance, and are topped with richly coloured African Blackwood ferrules. As a special treat for the neglected lefties of the knife world, one of them is cut with a left hand bias.


First up, the lefty

20230914_122827.jpg

20230914_122838.jpg

20230914_122846.jpg

20230914_122805.jpg

  • Blade: 252mmx57mm 52100 (64-65hrc) + nickel + low carbon san-mai/go-mai 1200 grit etch + polish
  • Neck: 18mmx17mm
  • Handle: 132mm long, 22mmx26mm tapering to 19mmx22mm, purple heart+blackwood, oiled and waxed
  • POB: 47mm from the hande
  • Spine: 3.35mm at the neck, 2.78mm at 1.5cm, .55mm 1cm from the tip
  • Grind: flat to convex, left hand bias
  • Weight: 209g
  • Relieved choil and spine
  • Edge: .17mm@1mm, .31mm@2mm, .48mm@5mm, .79mm@10mm Measured at the midpoint.







The righty...
20230914_122337.jpg

20230914_122405.jpg

20230914_122423.jpg

20230914_122354.jpg

  • Blade: 252mmx57mm 52100 (64-65hrc) + nickel + low carbon san-mai/go-mai 1200 grit etch + polish
  • Neck: 19mmx18mm
  • Handle: 130mm long, 22mmx25mm tapering to 19mmx21mm, purpleheart+blackwood, oiled and waxed
  • POB: 40mm from the hande
  • Spine: 3.29mm at the neck, 2.55mm at 13.5cm, .53mm 1cm from the tip
  • Grind: flat to convex, right hand bias
  • Weight: 194g
  • Relieved choil and spine
  • Edge: .14mm@1mm, .22mm@2mm, .43mm@5mm, .72mm@10mm Measured at the midpoint.
Asking $465 U.S + $25 U.S each (for shipping) or $900+ shipping for the pair, shipped with insurance anywhere in North America. Overseas will be in the ballpark of $50-$75 U.S depending on the area.

Note: If purchased as a pair, I'll need to ship them separately to insure them fully as the both will exceed Canada Post's 1000$ CAD limit for parcel insurance.


These knives came about as a way of testing a new set of drawing dies I made in the hopes of achieving lower, and more typical looking cladding lines. As part of the billet that these blade were cut from, another blade has been profiled, and received its HT. It's a 225mm x 55mm in a sort of bullnosed kono-fm type profile. Anyone can call dibs on that blade immediately as a semi-custom, but if no one claims it by the time I'm done with my current round of customs I'll grind and handle it as per usual.


Thank you for looking!

-Matt
 
Back
Top