Kind of an unusual bird. Takeda Chuka in white #1 with Stefan handle in what I believe is ebony & dyed maple.
The profile makes it a bit taller it the front than the heel. It's quite comfortable.
Acquired it years ago from a member (don't remember who though) on the other forum. Used it a handful of times since then.
Still has original Martell convex grind. Minor discoloration (patina) from storage. Asking $550 all in.
251mm long
91mm high @ heel
95mm high @ front (10mm back of tip)
4mm wide spine @ heel
2mm wide spine @ tip
Front rise through first @ 70mm of edge, then 130mm of flat, then 50mm of edge at rear rise (linear measure)
Weighs right around 500g
No micrometer so I can't get blade thickness measurements.
The profile makes it a bit taller it the front than the heel. It's quite comfortable.
Acquired it years ago from a member (don't remember who though) on the other forum. Used it a handful of times since then.
Still has original Martell convex grind. Minor discoloration (patina) from storage. Asking $550 all in.







251mm long
91mm high @ heel
95mm high @ front (10mm back of tip)
4mm wide spine @ heel
2mm wide spine @ tip
Front rise through first @ 70mm of edge, then 130mm of flat, then 50mm of edge at rear rise (linear measure)
Weighs right around 500g
No micrometer so I can't get blade thickness measurements.