I picked this knife up from Tower Knives when I was in Japan a year and a half ago. It’s stainless clad W#1 by Fujii Keiichi. I polished and etched the knife, which brought out some unexpected banding in the stainless cladding. I knocked off the stock ho handle and replaced it with a nicer rosewood/horn handle that I had laying around. The knife has been sharpened a few times, most recently finished on an Aiiwatani tomae and stropped on roo. Knife Specs Edge length: 260mm Heel height: 49mm Weight: 215g Spine @ handle: 3.0mm Spine @ heel: 2.8mm Spine halfway: 2.2mm Spine 1” from tip: 1.4mm Balance point: about 1-1/2” from the heel (at the base of the bottom kanji character) Purchased for $350; asking $275 shipped & insured ConUS. International buyers add $15.