dwalker
Senior Member
- Joined
- May 6, 2016
- Messages
- 1,220
- Reaction score
- 213
Running out of room for stones so here are a few I'm letting go. Buyer pays shipping and PP fees if there are any.
Kozaki Aoto from MM. $35
200x41x41, 710g. Typical aoto, very muddy, finishes around 3-4k with bite. Ok for kasumi.
Shobudani Tomae $100
Picked this one up from Badger a while back. 197x57x20 hardness is 3.5, 590g with base. This is one of my favorite finishers for blue steel. Will do kasumi with nice contrast.
Tshushima Nagura from JNS $175
Huge stone 212x80x52 2360g. Very nice finisher, can achieve a wicked edge. It is sticky on stainless cladding for kasumi but is doable with practice. No problem with iron cladding and leaves a very even cloudy finish.
Nub bamboo 150 $50
Large stone for repair or thinning 210x80x38. Scratch pattern is very easy to clean up with my SG500. Has some grooves on one side where I used it for tip repair.
Kozaki Aoto from MM. $35
200x41x41, 710g. Typical aoto, very muddy, finishes around 3-4k with bite. Ok for kasumi.
Shobudani Tomae $100
Picked this one up from Badger a while back. 197x57x20 hardness is 3.5, 590g with base. This is one of my favorite finishers for blue steel. Will do kasumi with nice contrast.
Tshushima Nagura from JNS $175
Huge stone 212x80x52 2360g. Very nice finisher, can achieve a wicked edge. It is sticky on stainless cladding for kasumi but is doable with practice. No problem with iron cladding and leaves a very even cloudy finish.
Nub bamboo 150 $50
Large stone for repair or thinning 210x80x38. Scratch pattern is very easy to clean up with my SG500. Has some grooves on one side where I used it for tip repair.