I was wondering if anyone had the means or time to compare the different stop compounds and different microns at what types of edges they create.
I think its most likely the finer you go the sharper the edge, however would it be too "slippery" at a certain point?
Also would certain compounds at the same micron leave a better edge than others?
Just curious if anyone has tested this or would be willing to.
I think its most likely the finer you go the sharper the edge, however would it be too "slippery" at a certain point?
Also would certain compounds at the same micron leave a better edge than others?
Just curious if anyone has tested this or would be willing to.