Search results

In that case, I wouldn't worry! That's pretty much been my experience... never ran into any I had to torch to drill. Though, this has somewhat piqued my curiosity. I have a couple of old Forgecrafts sitting around awaiting re-handles... when I'm home I'm going to pop the handles off and...

As others have said, the way to go for computer graphics to a piece would be electro or electrochemical marking. The actual device to do so is fairly easy to build, so long as you have a basic understanding of electrical circuits and soldering. There are plans on the internet which should be...

Hey Pete, I've drilled holes in a few Forgecraft tangs and found them to be quite soft towards the rear on a couple of them. So long as you were careful not to overheat it while grinding, I wouldn't sweat it. If you're unsure, it's not a bad idea to sharpen it up and give it a trial run...